PARROT BRIDGE
The browser host for your AI phone line. Plug in your board and connect — Parrot checks the firmware and takes it from there.
One-time setup
Set up & flash
Two quick steps: name this board and pick a couple of options, then flash the bridge firmware. You'll sign in first — setup links the board to your account.
1Set up device
2Flash firmware
Device name required
MAC
F0:24:F9:97:11:D8 · so you'll know it next timeReconnect this board
If USB disconnects while this bridge is running, reconnect the same board when it returns. After reloading, select your board again.
Board settings baked into the board — change by re-flashing
Status light on the board
Show the call on the board's LED: dark when idle, blinking on an incoming ring, a soft glow during a call that pulses while anyone talks. Turn it off if your board has no LED on GPIO2, or uses that pin for something else.
You'll sign in on the next step — setup links this board to your account.
This device
Connecting your board · Waiting for the board
Keep this tab open. The bridge runs here in your browser — closing the tab ends it and drops any active call. You can leave it in the background.
USB connection
Disconnected
Bridge is stopped
Device
No board identified
Name appears when the board responds
Server
Disconnected
Bridge is stopped
Phone audio
Inactive
Bridge is stopped
Connection details
- Device ID
Not identifiedOpen device ↗- Server URL
Not connected- Audio format
- μ-law · 16 kHz between the board and server
Board ready
Your board is ready to connect.
Start the bridge, then follow the Bluetooth pairing status. Keep this tab open while using your board.
You'll sign in once — running the bridge links this device to your account.
Advanced tools
Reset Bluetooth
Remove all phone pairings saved on this board. Then forget this board in your phone's Bluetooth settings and pair again.
Factory reset
Restore this board's default settings and clear its phone pairings.
© 2026 ParrotVoice, LLC · Web Serial + WASM bridge